CALIBRATION 17025

PZ HTL S.A. is pleased to announce that its calibration laboratory on the 21st of December 2016 has attained accreditation to the ISO/IEC 17025 standard by the Polish Centre of Accreditation. The Certificate confirms effectiveness of the quality management system, and also accuracy and reliability of tests within the laboratory for piston pipettes calibration.

HTL laboratory performs calibration of piston pipettes using gravimetric method, according to the EN ISO 8655-6 Standard, with calibration levels available:

Method 1.

The measuring procedure based on performance of a series of 10 measurements for 3 tested volumes (according to the instructions IQLs-03-QS to 7.1)

Method 2.

The measuring procedure based on performance of a series of 4 measurements for 3 tested volumes (IQL instructions QS-03-Section 7.2)

Calibration Certificate Sample

The range of measured volumes is presented in the table below:

Volume range
from 0,2 µl to 20 µl
from 20 µl to 50 µl
from 50 µl to 250 µl
from 250 µl to 1,000 µl
from 1,000 µl to 5,000 µl
from 5,000 µl to 10,000 µl

CALIBRATION 17025 ORDER PROCEDURE

Step 1   Fill in the form: Calibration Order Form

Step 2   Send the completed form to: htl.service@corning.com

Step 3    Please submit an approved offer to the Calibration Service

Step 4   Please send the pipettes to the address:

PZ HTL S.A.SERVICE-CALIBRATION

Daniszewska 4

03-230 Warszawa

POLAND

Step 5  The Calibration will be performed within 10 working days of receipt of the pipettes by the Laboratory.

 

“All information obtained in the course of providing the service to the Customer is protected and the customer is guaranteed that this information will not be disclosed to anyone without a written order or consent from him. Each calibration service performed in the Laboratory is carried out in a repeatable, impartial manner and each client is served with equal care.”

“The Client has the right to report a complaint about the service at any stage of its duration and is obliged to report any reservations concerning the quality of the services provided within 14 days from the date of receipt of the order in writing to the address: PZ HTL S.A. SERVICE Daniszewska 4, 03-230 Warsaw or by e-mail: HTL.SERVICE@corning.com. Otherwise, it is assumed that the service has been performed correctly. Any complaints will be dealt with in accordance with the Laboratory’s possibilities.”